AIM #910 Driveway Crack Filler Pour Grade is a latex modified asphalt emulsion sealant designed to fill cracks in asphalt or concrete horizontal surfaces. It blends with blacktop surfaces to prevent water seepage and the damage it can cause. This dramatically increases the life of the pavement. AIM #910 Driveway Crack filler Pour Grade is supplied in easy-to use gallon bottles with pour spouts. AIM #910 Driveway Crack filler Pour Grade may be top coated with either asphalt or coal tar driveway sealers.

1. Broom or hose down the area thoroughly to remove loose dust, dirt and debris.
2. Remove any standing water.
3. Shake the container well.
4. Remove the container top and invert the attached pour spout. Replace the cap with the pour spout extended.
5. Snip off approximately 1/8” of spout and direct the flow into the crack. Hand pressure on the container will allow the
material to flow evenly.
6. For cracks deeper than 1/2”, apply in 2 coats, allowing 12-24 hours between applications. This will reduce tracking.
7. If the surface is to be used prior to complete curing, fill cracks to ¼” from the top of the surface and lightly cover with
sand. This will help eliminate tracking.
COVERAGE RATE: 75-80 lineal feet for a ½” X ½” crack. Coverage rates will vary based on the size of the crack.
CLEAN UP: Soap & water may be used to clean this material prior to drying. Dried material may be cleaned with mineral
spirits or waterless hand cleaner. Use care when handling solvents.