PRODUCT INFO

ALL PRODUCTS

GET A QUOTE

Photo of a container of AIM #960 Emulsion Driveway Sealer, a private label product. The label clearly shows the product number. This sealer is designed to protect and beautify asphalt surfaces. Blended from refined asphalt, it promotes longer life and early wash-off resistance. It contains no harmful solvents and is free of coal tar odors, providing a tough, durable, rich black, track-resistant finish.

Available Sizes: Bulk, 5 Gallon

Uses

AIM #960 Emulsion Driveway Sealer is designed to protect and beautify sound asphalt surfaces. Blended from the high quality reined asphalt, AIM #960 Emulsion Driveway Sealer promotes longer life and early wash-off resistance. This product contains no harmful solvents and is free of the irritating odors associated with Coal Tar sealers. AIM #960 Emulsion Driveway Sealer will provide a tough, durable rich black finish, which is resistant to tracking.

Description

Specifications

Coverage: 100 square feet per gallon for smooth or previously sealed surfaces (500 sq.ft. /5 gal.). Rough, porous or previously unsealed driveways may require slightly more.

Application

PREPARATION

  1. CLEAN surface to be coated. Sweep off all loose dirt, dust and debris. Scrub grease and oil spots with an all-purpose detergent. Flush cleaned area with garden hose using strong water pressure.
  2. REPAIR all cracks and potholes larger than 1/8″. Cracks smaller than 1⁄2″ may be repaired using AIM #910 Driveway Crack Filler Pour Grade. Larger cracks, holes and depressions should be repaired using AIM #920 Driveway Crack Filler Trowel Grade or AIM #940 Pothole Patch. Allow repaired areas to properly cure before sealing.

APPLICATION

  1. STIR slightly to assure uniformity. AIM #960 Emulsion Driveway Sealer Asphalt Driveway sealer is designed to eliminate any hard-packed settling. Little stirring is required. Do not thin.
  2. LIGHTLY DAMPEN the surface with water when applied in temperature above 80 degrees. Surface may be damp during application but puddles of water should be avoided.
  3. APPLY sealer with a roller or long handled Driveway Applicator, (squeegee on one side and brush on the other), at a rate of 1 gallon per 100 square feet. To assure proper coverage, measure out 1 gallon of sealer and apply to a premeasured area of 100 square feet (10 ft. x 10 ft.). Spread sealer evenly and thinly with the squeegee part of applicator. Use the brush end of applicator to work sealer into rough areas and remove excess sealer from low areas.
  4. FINISH the area with a light pass of the brush assuring that all finishing strikes are in one direction for best appearance. Using the above application rate, continue to pour, spread and brush the sealer over the remaining surface.

HELPFUL HINTS & PRECAUTIONS

  • This product will cure in 4 hours for light vehicle traffic when applied according to labeled instructions. Temperatures below 65° F and relative humidity above 60% will increase the cure time.
  • Avoid parking vehicles on coated surface for 24 hours.
  • Apply coating in the morning on a clear sunny day with temperatures at or above 65°F. This will allow the coating the benefit of the full day’s sunshine.
  • The old adage “more is better” does not apply to driveway sealers. Recommended coverage rates should be followed as close as possible. Over application can dramatically increase cure time, tracking and may cause the surface to become slippery.
  • Allow new driveways a period of 6 months to cure before sealing.
  • Do not apply to concrete.