PRODUCT INFO
ALL PRODUCTS
GET A QUOTE
Uses
AIM #360 Premium Wet/Dry Elastomeric Flashing Cement is an asphalt based roof cement designed for repairing roofs and roof flashings that are wet or under water. This permits repairs immediately and can prevent more extensive water damage.
Description
AIM #360 Premium Wet/Dry Elastomeric Flashing Cement is manufactured from Type I Roofing Asphalt, polymer modifiers, reinforcing fibers, petroleum solvents and a special additive which displaces moisture and allows application to wet surfaces.
Specifications
Applicable Specification: ASTM D4586 Type I, Asbestos Free
| Viscosity | Trowel | |
| Recommended Rate of Application | 1/8 to 1/4 inch thick | |
| Wet Adhesion | 100% | ASTM D3409 |
| % Asphalt | 45 min. | ASTM D6511 |
| % Solids | 70 min. | ASTM D6511 |
| % Non-volatile | 86 max. | ASTM D6511 |
| Weight per Gallon | 1/8 to 1/4 inch thick | |
| Flash Point (TCC) | +100°F (38.7°C) | |
| VOC | Less than 250 g/l |
Application
The surface to be repaired must be clean and free of debris. Apply AIM #360 Premium Wet/Dry Elastomeric Flashing Cement evenly with a pointed roofer’s trowel or gloved hand. Use sufficient pressure to force water out from underneath the mastic as it is applied. AIM #360 Premium Wet/Dry Elastomeric Flashing Cement should be applied 1/8 to 1/4 of an inch thick and may be reinforced with glass membrane or polyester fabric to strengthen the repair. Repairs made to wet surfaces should be considered temporary as trapped moisture will expand when heated by the sun causing blisters and potentially new leaks. When making a permanent repair, open up the area and allow it to dry thoroughly.
Clean up with mineral spirits or waterless hand cleaner. Use care when handling solvents.
